Press CODE SET
button
fi
ve times
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the door for pet position
Fig. 32
Fig. 33
Fig. 34
Coding Transmitters
Step 17.5 - Setting the Transmitter to Operate Pet
(Pedestrian) Mode
The opener can be programmed into a “Pet Mode” where the
door opens partially to allow pets to enter/exit the garage:
a. Press the CODE SET button
fi
ve times, the CODE SET
LED will illuminate and the courtesy light will
fl
ash
quickly (twice per second) to indicate learning mode for
Pet Mode is active.
b. Choose a transmitter button not already coded into the
receiver. Press this button and the CODE SET LED will
begin to
fl
ash.
c. Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go out,
and the courtesy light will also switch off. This indicates
the code has been stored. This indicates the code has
been stored
(Fig. 32)
.
Step 17.6 - To Erase Programmed Codes
If the CODE SET button is pressed and held for 6 seconds the
CODE SET LED will blink rapidly for one second to indicate
that all programmed codes have been erased.
(Fig. 33)
Step 18 - Installation of the Wall Mounted
Transmitter
a. Mount the transmitter in a convenient location, yet out
of reach of children and at least 1.5m off the ground
(Fig. 34)
.
b. Make sure the door is visible from this location.
c. To set the transmitter codes refer to Step 17.1.
Controll-A-Door
®
P
Diamond SDO-2v2
Instruction Manual
20
Summary of Contents for Controll-A-Door P Diamond SDO-2v2
Page 37: ......
