B&D Controll-A-Door P Diamond SDO-2v2, Instruction Manual

How To Use Your Opener

Safety Beam

A Safety Beam Kit (Part No 062734) may be 

fi

 tted to this 

opener. 
• 

When this option is 

fi

 tted, the operation of this device 

is such that if an object (i.e. car, child, etc.) blocks 
the Safety Beam, then the garage door opener will not 
close the door automatically.

• 

If the Safety Beam is 

fi

 tted but not operating correctly, 

then the door once opened automatically, will not close 
automatically. The door may be closed by reverting to 
manual operation – see Manual Operation. 

Auto-Close Option

To have the Auto-Close option functional you must also have 
a Safety Beam (Part No 062734) 

fi

 tted and functioning. 

To enable the Auto-Close function, place the AUTO-CLS 
jumper on both pins

When this option is selected the garage door opener will 
attempt to close the door automatically 30 seconds after 
opening.

If the Safety Beam is interrupted whilst the door is closing 
(e.g. by a person walking through the doorway), the door 
will reverse to the fully open position.

If the door does not close automatically, you may close the 
door using the Manual Operation.

Courtesy Light

The Courtesy Light will illuminate for approximately four (4) 
minutes each time the door is operated automatically. 

Spare buttons of a multi-channel transmitters can be 
programmed to turn the light on and off by remote control.

See Step 17.2 for more information. 

Auxiliary Output

This function allows the opener to operate other devices 
such as external lights or an alarm system. 

To use this function, a spare button of a multi-channel 
transmitter must be programmed to operate the Auxiliary 
Output feature. 

See Step 17.4 for more information. 

Vacation Mode

The radio receiver of the garage door opener can be 
turned off to all but one transmitter via Vacation Mode.  
Whilst in vacation mode the opener will not respond to 
any transmitter.

To activate the Vacation Mode facility, see Step 17.3.

NOTE - program only one button to control “Vacation 
Mode”. This will reduce the possibility of accidental 
activation of this feature.

Pet (Pedestrian) Mode

A transmitter can be programmed to open the door 
partially to allow pet access to the garage. 

To activate Pet Mode press the transmitter button that 
has been programmed for Pet Mode - the door will 
open partially. 

See Step 17.5 for more information. 

Service

While the door opener does not require regular 
servicing, to function correctly the door must be in 
good operating condition. As a reminder the SDO-
2v2 has a built in maintenance counter. This counter 
has a factory default of 3000 cycles, which is the 
recommended service interval.

When this counter expires the yellow SERVICE LED will 
light up and opener beep three times at the start of 
each cycle. In addition the courtesy light will 

fl

 ash and 

opener beep 

fi

 ve times at the end of open cycle (when 

the door is fully open).

These warning signals will self extinguish after 30 
cycles. 

When this service counter is triggered it is 

strongly recommended you contact your garage door 

dealer to arrange a door service.

However, if you choose not to have your door serviced 
the counter can be reset simply by pressing the LIMIT 
SET button. 

Diamond PD Power Drive : Instruction Manual

© Copyright 2012 B&D Doors

29

Controll-A-Door

®

 P

Diamond SDO-2v2

Instruction Manual