2
Smart Pro
installation instructions
Contents
1. Installation Safety Warnings!
10.1 Inserting batteries into receiver and transmitter
10.1 Assemble the Mounting Bracket
10.3 Aligning the Transmitter and Receiver
12.1 Set the Limit Positions and adjust drive speed:
12.2 Clearing the Door Limit Positions
13.3 Test the Manual Door Operation
14.3 Connecting or Disconnecting Accessories
Installation Instructions
Home Owner Instructions
WARNING! IMPORTANT SAFETY INSTRUCTIONS
FOLLOW ALL INSTRUCTIONS SINCE INCORRECT INSTALLATION CAN LEAD TO SEVERE INJURY.
•
before installing the drive, remove all unnecessary ropes or chains and disable any equipment, such as locks, not needed for
powered operation;
•
before installing the drive, check that the door is in good mechanical condition, correctly balanced and opens and closes
properly;
•
install the actuating member for the manual release at a height less than 1,8 m;
•
install any fixed control at a height of at least 1,5 m and within sight of the door but away from moving parts;
•
permanently fix the labels warning against entrapment in a prominent place or near any fixed controls;
•
permanently fix the label concerning the manual release adjacent to its actuating member;
•
after installation, ensure that the mechanism is properly adjusted and that the drive reverses when the door contacts a 40 mm
high object placed on the floor.
•
necessary information for the safe handling of a drive weighing more than 20 kg. This information shall describe how to use the
handling means, such as hooks and ropes;
•
the drive must not be used with a door incorporating a wicket door (unless the drive cannot be operated with the wicket door
open);
•
after installation, ensure that parts of the door do not extend over public footpaths or roads.
•
vertical doors and gates need an anti-drop feature or device;
•
information if a hazardous part of the drive is intended to be installed at a height of at least 2.5 m above floor level or other
access level;
•
except for horizontally moving pedestrian doors, ensure that entrapment due to the opening
movement of the driven part is avoided
15.1 Storing the Transmitter Code
15.2 Remotely Coding Transmitters
15.3 Erasing All Transmitter Codes
15.5 Installation of the Wall Mounted Transmitter
17. Home Owner Safety Warnings!
18.1 Your Door CAN NOT be used when:
18.2 Your Door CAN be used when:
A - Status Indication during Operating Mode.
B - Adjustment Mode Instructions
E - Setting the PET mode position
