9
Smart Pro
installation instructions
10. Safety Beam Kit
10.1 Inserting batteries into receiver and transmitter
a. Insert two (2) C-Type batteries into the Receiver (RX) and the Transmitter (TX) by removing the front cover.
b. Put cover back on Transmitter and Receiver and secure with four (4) M6 x 25 screws (black).
WARNING! The Opener must be fitted with Safety Beams if:
• the closing force at the bottom edge of the door exceeds 400N (40kg) and/or;
• the opener has a smart device fitted to operate the door, when not in line-of-sight.
4
1
5
2
3
5
Right side
bracket
CAUTION! The Safety Beam must be installed and connected before the travel limits are set.
65mm
100mm
TX
Sun or Shade
Receiver
RESET
LED
Apply pressure here Pull covers apart
10.1 Assemble the Mounting Bracket
a. Attach the PE 2000TS Bracket
1
to the Safety Beam Transmitter
(TX) using four (4) M3 x 5 Taptite screws
4
.
b. Connect the mounting bracket
3
to the adjustment bracket
2
with two (2) of the M5 x 10 Pan Head Screws
5
.
c. Repeat steps (a) and (b) to assemble the Safety Beam Receiver
(RX).
d. Mount the receiver on the side of the doorway in shade and the
transmitter on the other side in line with the receiver. The mounting
surface should be rigid. Affix with a minimum of four (4) screws
(not supplied).
10.2 Mounting the Bracket
The transmitter and receiver need to be placed in line of sight, with
the beam 100mm above the ground level (as per AS/NZS 60335-
2-95:2020). This can be achieved by ensuring the bottom of the
receiver and transmitter are 65mm above ground level. They should
also be placed as close as possible to the door opening with the
receiver (RX) in shade and the transmitter (TX) in sun or shade.
Assembling Flush Mounting Kit (for minimum sideroom applications)
a. Attached the transmitter (TX) and receiver (RX) to the two (2)
PEB4-W1 Bracket
1
with the four (4) M3 x 8 Taptite screws “P”
4
.
b. Ensure to take note of the ATA recommendation in step (d) above
and fix the TX and RX to the wall or rigid surface using the two (2)
6.9 x 25 plastic wall plugs (if wall) and two (2) M6 x 25 self tapping
screws.
10.3 Aligning the Transmitter and Receiver
a. Power up the opener with the safety beams connected.
b. The LED on the receiver and transmitter will light up and flicker.
indicating communication is being established between each
unit and the base station. This can take up to 60secs. Lights will:
(i) Stay on solid = When communication is established but limits are not set.
(i) Go out = When communication is established and limits are set.
b. The opener beam alignment feature can be used to align beams via the beeper
and main light as a guide;
(i) bright = aligned
(i) dull and Beeper sound = not aligned or blocked.
When the beams are aligned, continue with Section 12 Setting Limits.
