51806-001 en/2021-12
17 / 43
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
3.4
Setting the operating parameters
By pressing the [SET] key, the editing mode is activated.
Depending on the operating mode used to call up the editing mode, it will be possible
to change di
ff
erent operating parameters:
Call-up from
Editable parameters
Stand-by mode
Target runtime, target temperature and target power
Active mode
Target temperature and target power
Pause mode
Remaining runtime (without changing the target runtime!),
target temperature and target power
It is possible to switch between the individual parameters by pressing the [
] key or [
] key.
The settings can be changed by pressing the [
] and [
] keys. Each of the editable
parameter positions is displayed inversely. Changes made become immediately active.
3.4.1
Temperature setting
The temperature can be changed at any time in editing mode.
Setting limits: 4-40 °C
Example: taken from stand-by mode
Editing mode ( temperature)
12:00:00 17.0°C 50%
Temperature:
17.2°C
17
12:00:00 17.0°C 50%
12:00:00
17.2°C
12:00:00
SET
Notes:
• If the actual temperature exceeds the value of the target temperature by more than
+ 1.0 °C, the ultrasonic bath will shut o
ff
the ultrasound for safety reasons (ultrasound
energy heats up the liquid). If the limit value is exceeded before the start, it will not be
possible to activate the ultrasound. The status LED will blink red.
• The ultrasonic bath will independently activate the ultrasound if the actual temperature
is once again within the stated tolerance range.
• The set time will only be counted during active ultrasound emission.
• If the target value for the temperature is higher than the actual temperature,
only a warning will be issued and the ultrasound may be started. The status LED
will blink yellow.
• With a target temperature below 15 °C, the ultrasound may be occasionally switched
o
ff
under normal ambient conditions (approx. 20 °C).
This can be prevented by reducing the ultrasound power setting.