1
Mains switch
Turning generator on or off
2
Digital timer Display
3
Pulsation level
Display
4 Power
display
Display
5
Power control dial
Used for in
fi
nitely variable setting of the amplitude (10 - 100 %) during operation
6
Control light
Lit green during operation
7
"Start/Stop" key Starts or stops the entered program.
Optional with button on the ultrasonic transducer or the foot switch.
8
Type "+" / "-": the blinking value increases or decreases by one unit.
Press and hold (> 2 sec):
the blinking value increases or decreases through a fast scroll.
9
"Mode" key
Used for step-by-step modi
fi
cation of the time entries - minutes, seconds and pulsation
level - and at the end for saving in countdown or continuous operation.
10 "Reset" key
Interrupts the current program
Switches from countdown operation to continuous operation and vice versa.
1
2
3
4
5
10
9
8
7
6
2.3
Start-up
Check the positioning of the ultrasonic transducer in the holder.
Check the
fi
rm positioning of the probe and, if needed, clean thoroughly before
fi
rst use.
Connect the HF generator to the mains ( grounded socket) and switch on.
Conduct a function test pursuant to chapter 6.2.
3
Operation
3.1
Operating elements
Operation is conducted from the operating and display panel on the front side of the HF generator:
15 / 44
51436a GB/2017-10
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
