51846-000 en/2022-07
17/36
Operation
/5
5.3 Start sonication
Requirement
• The probe tip is immersed in the sonicating medium; see
.
1. On the startup screen, tap the "Start" button.
» The “Sonication” screen appears.
» The preselected sonication parameters are displayed; see
2. Optional: Tap one of the buttons "Amplitude," "Power," "Time," "Pulsation" or
"Temperature" to change the preselected settings for the current sonication.
Confirm the new settings by tapping the "Confirm/Save" button.
3. Tap the "Start" button at the bottom of the screen.
» The sonication begins.
» If the timer was set, the sonication ends automatically after the set time.
» You can interrupt the sonication at any time with the "Pause" button or end
it with the "Stop" button.
» After the end of sonication, a screen with a summary of the sonication
appears.
4. Tap the "Confirm/Save" button.
» The sonication screen reappears with the last settings.
5.4 Creating and starting programs
5.4.1 About programs
Programs are saved parameter sets for sonication. Amplitude or power, time and
pulsation are stored in a program. A total of eight programs can be stored. Each
program can be active or inactive. The sequence in which the programs are exe-
cuted can be defined as required.
5.4.2 Creating a program
1. On the startup screen, tap "Programs".
» The "Programs" overview screen is shown.
2. Tap on a program number.
3. If a screen with the summary of the program parameters appears, tap "Edit".
4. Tap the "Ampl./Power," "Time" or "Pulsation" button to edit the program
parameters; see
Preselect parameters for sonication
. Confirm your entry
with the "Confirm/Save" button.
5. Tap the "Confirm/Save" button to save the program.
