1 Ultrasonic bath ON/OFF button
2
Preset time button
3
Start/ Stop button – Ultrasound
4 LEDs for time
4
1
2
3
12 / 32
51326c GB/2017-06
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
3 Operation
3.1
Operating elements
The unit is operated at the front:
3.1.1
Ultrasound
With the ultrasonic bath turned on – ON/OFF button – after the time is
preset, the ultrasound output is turned on with the Start/ Stop button.
Timed operation:
• Setting via pressing buttons
Time 1, 2, 3, 4, 5, 10, 15 or 30 minutes; the corresponding, yellow LED lights
up on the time scale
- Following pressing of the Start/ Stop button, a running light displays the
remaining time optically.
- Once the time expires, the ultrasonic output is stopped automatically.
• Premature pressing of the Start/Stop button ends the ultrasound output.
Continuous operation:
• Setting via pressing buttons
LED
lights up
- Following pressing of the Start/ Stop button, the top (green) LED lights up
constantly.
- Ultrasonic bath does not turn off automatically:
press the Start/Stop button to switch it off.
Caution:
For safety reasons, the ultrasound bath is turned off automatically if no button is pressed for more
than 12 hours.
Note
• While turned off, the ultrasonic bath may remain connected to the mains.
It can be disconnected from the mains by pulling out the mains plug.
Summary of Contents for Sonorex Digitec DT 510 F
Page 25: ......
