51396c GB/2019-04
11 / 27
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
2 Preparation
Carefully unpack the ultrasonic bath and accessories and inspect them for
completeness or possible transportation damages. If any damages or defects are
found, these must be immediately noti
fi
ed in writing to the transportation company and
to the supplier.
Before operation, the ultrasonic bath should be allowed to stand for 2 hours at its
operating location so that it can adjust to the ambient conditions.
2.1
Scope of delivery
1 ultrasonic bath (PR 140 D), optionally with heating (PR 140 DH)
1 basket K 140 B
1 lid D 140 D
1 ball valve (brass, galvanized) with hose socket and hose, packaged separately with
sealing tape and assembly instructions
1 instructions for use
1 TICKOPUR R 33, 5 liter
1 TICKOPUR TR 3, 1 liter
Additional accessories according to order – see delivery slip
2.2
Set-up / assembly
• Place the ultrasonic bath atop a
fi
rm, level and dry surface. In doing so
- make sure that there is a
fl
oor drain in the immediate vicinity,
- do not block the air supply below the ultrasonic bath,
- guard against moisture and wetness – risk of electric shock.
• Install the ball valve, hose socket and hose, which are included in the delivery,
pursuant to the enclosed assembly instructions.
2.3 Start-up
Thoroughly rinse the ultrasonic bath's oscillating tank with water before its
fi
rst use.
Connect the ultrasonic bath to the power supply (grounded socket).
Conduct a function test - switch on ultrasonic bath, brie
fl
y switch on and turn off the
ultrasound (maximum of 1 to 2 seconds), a hissing noise should be heard. Then,
switch the device off again.
Place accessories in the ultrasonic bath and place lid on top.
