1676-002 en/2022-05
29/52
Maintenance
/6
6 Maintenance
6.1 Cleaning and maintaining the ultrasound bath
Cleaning the housing
• Wipe the housing with a damp cloth. Wipe dry with a soft cloth.
• Do not use abrasive cleaning agents, only care products without
scouring additives.
• If necessary, disinfect the housing with a suitable surface disin-
fectant.
Care of the oscillating tank
Impurities in the oscillating tank accelerate the tank’s wear, can
lead to corrosion and reduce the ultrasound effect. Therefore,
please observe the following instructions:
• Rinse the oscillating tank thoroughly with water after each use.
Wipe dry with a soft cloth.
• Clean edges and remove residues with a stainless steel care
product without abrasive additives.
• Do not use steel wool, scrapers or shavers to clean the oscillat-
ing tank.
• Metal parts and rust particles in the oscillating tank cause corro-
sion. Therefore, do not leave any metal parts in the oscillating
tank. If rust stains are visible, remove them immediately with a
soft cloth and a stainless steel cleaning product without abra-
sive additives.
6.2 Tests
NOTICE
Damage to the ultrasound bath
– Perform tests only on a filled ultrasound bath.
If one of the tests does not produce the desired result, contact Ser-
.