23626-002 GB/2021-10
21 / 24
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
6.3.1 Repairs and service
If faults or defects have been discovered and cannot be recti
fi
ed, the lifting device
must be taken out of service immediately. If this occurs, please contact the supplier or
the manufacturer:
BANDELIN electronic GmbH & Co. KG
Heinrichstrasse
3-4
12207
Berlin
Repair
service:
Email:
Tel.: +49 (0)30 7688 013
info@bandelin.com
Fax: +49-(0)-30 - 76 88 02 00 13
In the event of returns, the General Terms and Conditions for Delivery and Payment of
BANDELIN electronic GmbH & Co. KG apply.
The lifting device must also be cleaned and decontaminated (if necessary) –
see the next section.
6.3.2 Certi
fi
cate of Decontamination
If the lifting device is sent back to the manufacturer for repairs (with accessories,
if applicable), the form “Certi
fi
cate of Decontamination” must be
fi
lled out and a
ffi
xed
in a clearly visible location on the outside of the packaging.
If this form has not been
fi
lled out, we reserve the right to refuse receipt of the package
in order to protect our employees.
The form can be downloaded as a PDF
fi
le from our website:
www.bandelin.com – Downloads ...
6.3.3 Replacing fuses
CAUTION!
Repair work may only be carried out by authorised, quali
fi
ed personnel or by
the manufacturer. The manufacturer assumes no liability for unauthorised work on
the device!
Always disconnect the mains plug before opening!
Risk of electric shock from live parts in the control box!
Disconnect the lifting device from the mains power.
Loosen the screws in the control box and lift up carefully.
The fuses are installed in the locking clips.
After inspection, replace only the defective fuses. The fuse values are listed under
“Technical Data”, see chapter 1.4.
Reassemble the control box by following the steps in reverse order.
Reconnect the mains cable.
Summary of Contents for SONOREX TECHNIK MB
Page 24: ......
