13
2 Preparation
Carefully unpack the ultrasonic/rinsing bath and accessories and inspect them for
completeness or possible transportation damages. If any damages or defects are
found, these must be immediately noti
fi
ed in writing to the transportation company and
to the supplier.
Before startup, the ultrasonic bath is to be left to stand at its operating location for
2 hours so that it may adapt to the ambient conditions.
2.1
Scope of delivery
1 Ultrasonic/rising bath, see delivery note
1 Accessories kit
1 Instructions for Use manual
Additional accessories according to order - see delivery note
2.2
Set-up / assembly
• Place the ultrasonic/rinsing bath on a
fi
rm, level and dry surface. In doing so
- observe the maximum weight of the tank, including liquids.
For net weight, see technical data, chapters 1.4.1 to 1.4.3.
- do not block the air supply below the tank.
- guard against moisture and wetness - risk of electric shock.
Set-up
Fully remove transportation aids (pallets, transport safety devices).
Set up the ultrasonic/rinsing bath in a dry room.
Mount the separately-packaged ball valves for each tank as follows:
1. Screw the counter nut onto the threaded sleeves 1 at the
tank outlet (3-way ball valve) and tank over
fl
ow (ball valve),
then seal with the white PTFE tape provided, applying
several turns of tape to the right.
2. Tape the hose socket threads 2 with PTFE sealing tape.
3. Screw the hose sockets 2 into the ball valve outlets 3, use
the appropriate spanner.
4. Screw the ball valve 3 onto the threaded sleeves and
tighten with the counter nut 4.
Caution:
Do not screw the ball valve up to the limit stop
or back it off by rotating it slightly to the left, this will cause
the PTFE tape to lose its sealing effect.
5. Close ball valve, turn the lever 5 upwards.
View from above:
4
1
3
2
5
open
open
cl
osed
2
screwed-in
