23536 GB/2017-03
15 / 22
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
4.2
General application
Step 1:
Test cable connections
Verify that all connecting cables and couplings are correctly connected.
Step 2:
Prepare for sonication
To do so, see the corresponding Instructions for Use for assemblies, ultrasonic
transducer systems, etc.
Prepare the sonicating medium and check that the
fi
ll level is correct.
Step 3:
Start ultrasound operation
TG ...
Insert mains plug
TG ... Z
Set timer to required time.
Step 4:
Stop ultrasound operation
TG ...
Pull out the mains plug
TG ... Z
Set time switch to "0" again.
4.3
Further information
- not applicable -