H3000 Pilot Handbook
107
HB-3001-03
Fault 101 – Pilot Compass Failure
Fault Description
No valid data is being received from the Halcyon Gyro-Stabilised Compass (HGSC)
sensor connected directly to the Pilot computer.
Remedial Action
1)
Is an HGSC sensor in use?
Yes
go to step (3)
No
go to step (2)
2)
Ensure that the Heading Source is set to the correct value for the
compass sensor in use.
SETUP
COMMISSIONING
HEADING SOURCE
3)
Check all wiring connections to the compass unit. There should be both
a sensor cable AND a 12V supply cable, see page 87 or 88
Fault 102 - Rudder Sensor out of Range
Fault Description
The signal from the rudder reference unit is outside the limits set during
commissioning. This usually indicates either a worn sensor or loose components.
Remedial Action
1)
Check installation of rudder reference unit for slack or loose fittings.
Replace any worn parts and secure any loose items. If the position of
any part has been changed it is necessary to follow the Dockside
Commissioning procedure.
2)
Display the Pilot screen on a GPD, watch the rudder indicator carefully
whilst turning the helm slowly from hard-over port to hard-over starboard.
The indicated angle should change smoothly as the wheel is turned.
•
If the indicator does not move at all follow the Dockside Commissioning
procedure
Summary of Contents for h3000
