H3000 Pilot Handbook
39
HB-3001-03
Now the swing is complete its important to eliminate any constant error in heading
due to the physical alignment of the sensor relative to the fore / aft line of the
boat.
This is normally checked for by using shore-based transits, once the error is known
it can be eliminated by entering the value into the system under:
SETUP
CALIBRATION
HEADING
SET OFFSET VALUE
(Enter new
value)
↵
For example, the compass was reading 320 degrees and it should read 316, then the
value to enter would be –4 from the current set value
Heading Source Selection
The H3000 System can accept heading data from a variety of different sources.
These different sources are known as Nodes and allow the system to identify which
heading devices are connected to the system.
DAMPING
SETUP
DAMPING
Another important facility that you need to be constantly aware of is the damping
available on certain functions. This allows you to filter signal noise on the function
when in unstable or rough conditions.
The damping works by applying a filter over a time period; the more you increase
this time period, the smoother the data readings will be, but the longer it will take
to see the effect of any change. Similarly the lower the time period the greater the
jumps you will see in the numbers, but the response to any change will be faster. It
is recommended to use the smallest value which still gives stable data.
Dynamic Damping
Dynamic Damping adjusts your system to deliver the most accurate and real-time
information, i.e. when on a beat, it is essential that the wind angle information
is accurate but steady with most ‘noise filtered out, however, when tacking, data
Summary of Contents for h3000
