Network page, view the Device Configuration dialog for each
sensor, and set the
Location
to match the engine the device is
connected to.
Unconfigure
- defaults the device which clears all user settings.
Reset Fuel Flow
- restores only the Fuel K-Value setting, if set in
Calibrate. Only Navico devices can be reset.
Calibrate
Calibration may be required to accurately match measured flow
with actual fuel flow. Access calibration from the
Refuel
dialog.
Calibration is only possible on Navico’s Fuel Flow sensor.
1.
Start with a full tank and run the engine as it would normally be
operated.
Software Setup
| Vulcan Series Installation Manual
45
Summary of Contents for Vulcan Series
Page 1: ...ENGLISH VulcanSeries Installation Manual bandg com...
Page 2: ......
Page 8: ...8 Preface Vulcan Series Installation Manual...
Page 64: ...988 11099 001 0980...