B&G ZM Series, User Manual

16 | 

Cleaning and maintenance  |  

ZM Series User Manual

Cleaning and maintenance

If the display requires cleaning, use a damp soft cloth (e.g. microfiber) with a mild, non-
abrasive glass cleaner. Ensure cloth is regularly washed or replaced.

¼

Note: 

Do not use paper products as they may scratch the surface. To minimize the risk of 

abrasion, allow the screen to air dry. 

¼

Note: 

Never use acidic, ammonia based, or abrasive cleaning products to clean the display. 

These products will damage special coatings on the glass.

¼

Note: 

To prevent damage caused by lightning strikes, it is recommended to disconnect the 

display from the power source during intense storms, or when the product is not in use for 
extended periods.

Display removal

The display’s top and bottom bezel trim 
must be removed in order to undo the 
fasteners holding unit in place by the 
mounting flange. The bezel trim have 
been designed to be very low profile, and 
therefore fully conceal the locking tabs 
that keep them from being accidentally 
disengaged from the mounting flange. To 
release the locking tab, it is necessary to 
gently lever the centre of the bezel trim 
away from the mounting flange. To remove 
the cover, simultaneously slide it sideways; 
to the right for the top cover, and to the left 
for the bottom cover.

The mounting brackets should be loosened 
in reverse order to fitting. To remove the 
brackets, depress the locking tab before 
sliding brackets upwards.

Replacing the gasket

The foam gasket on the rear of the display bezel is available as an optional accessory, should 
the factory installed item be damaged.

Fit the two lengths of foam gasket in to the 
rebated channel on the back of the displays 
mounting flange. Only remove backing 
paper from the side to be stuck to monitor, 
and only remove a small amount at a time. 
Ensure the gasket ends of the two halves 
overlap and make contact.

¼

Note: 

take care not to stretch gasket when applying. Only pull gasket minimum amount 

required to lay it on straight. The backing paper on outside of gasket will help prevent stretch, 
and should only be removed when display is ready to install in to dashboard.

8