| 5
Display installation |
ZM Series User Manual
CLICK
Wind in the wing screw, until stoppers make
firm contact with rear of dashboard material.
Check front of unit, ensuring that unit’s bezel is
making even contact with the dash surface.
Hand tighten wing nuts against the back of
the mounting brackets to lock the wing screw
in place. Hold wing screw stationary if it turns
while adjusting the wingnut.
When fitting bezels, ensure hook tabs on back
of each bezel recess into opposing slots on
screen frame. Once flush with front surface of
screen, slide top bezel to the left, and bottom
bezel to the right to lock in to place.
With bracket making contact with back of
monitor, slide bracket down till it engages
with a click and is held in place.
Fit brackets to rear of display, aligning ‘key
holes’ on bracket with screws on back of
display case.
Summary of Contents for ZM Series
Page 1: ...ENGLISH ZMSeriesMonitors User Manual bandg com...
Page 22: ......
Page 23: ...988 10693 001 0980...
