Bandit
35
Copyright 12/17
MODELS 2890SP/2900T
1. Grease grading blade bushings (if equipped):
Grease steering axle pivot bushings with 1 to 2 shots
ofEP-2Lithiumtypegrease.Wipeoffexcessgrease.
Excessive grease will attract dirt.
2. Check grinder bearings and grinder sheaves
(belt driven cutter wheels only):
On machines with a belt driven cutter wheel, check
and retighten all bearing bolts and belt sheave
bushings to correct torque.
MONTHLY MAINTENANCE
3. Check bearing and bearing lock collars (belt
driven cutter wheels only):
On machines with a belt driven cutter wheel, check
and retighten bearing lock collars to correct torque.
4. Check hydraulic function pressures:
Check, reset and maintain all hydraulic function
pressure settings to a maximum of the specified
PSI (bar). This will give you the best performance
from the hydraulic system.
1. Grease swing pivot assembly bushings
:
Grease the top and bottom swing pivot assembly
bushings with 1 to 2 shots of EP-2 Lithium type
grease.Wipeoffexcessgrease.
Excessive grease
will attract dirt.
2. Grease steering axle pivot bushings (2890SP)
:
On model 2890SP, grease steering axle pivot
bushings with 1 to 2 shots of EP-2 Lithium type
grease.Wipeoffexcessgrease.
Excessive grease
will attract dirt.
3. Grease steering bushings (2890SP)
:
On model 2890SP, grease steering bushings with
1to2shotsofEP-2Lithiumtypegrease.Wipeoff
excess grease.
Excessive grease will attract dirt.
4. Grease cylinder lug pin bushings
:
Grease cylinder lug pin bushings with 1 to 2 shots of
EP-2Lithiumtypegrease.Wipeoffexcessgrease.
Excessive grease will attract dirt.
5. Grease swing out pivot bushings(if equipped)
:
Grease swing out pivot bushings with 1 to 2 shots of
EP-2Lithiumtypegrease.Wipeoffexcessgrease.
Excessive grease will attract dirt.
6. Lubricate all steel friction areas:
:
Lubricate all steel friction areas including , but not
limited to pivoting, hinged, sliding, rotating areas on
the machine (i.e. cutter wheel guard, control box
doors, etc.).
7. Check the cutter wheel hydraulic motor
coupler (beltless drive cutter wheel):
On machines with a beltless driven cutter wheel
remove the stub shaft over the cutter wheel hydraulic
motor coupler and check the torque of the coupler
bolts, see Torque Chart.
8. Check set screws in bearings (belt driven
cutter wheels only):
On machines with a belt driven cutter wheel, check
set screws in cutter wheel bearings for tightness.
9. Check alternator and fan belts on engine (as
applicable):
Adjust and maintain per the engine manufacturer’s
manual.
10. Check wheel lug nuts (2890SP):
On model 2890SP, keep lug nuts tight, retorque,
replace if needed.
WEEKLY MAINTENANCE
23. Check around machine:
Check around the entire machine for tools, cans,
saws, etc. All tools not in use should be stored in
a tool box.
24. Review all safety procedures on decals, from
manual, and from video.
25. Make sure all safety equipment is being worn:
Make sure you are wearing all of your safety
equipment: hard hat, face shield, gloves, eye
protection, ear protection, etc. per ANSI and OSHA
standards.
26. Remember to check EVERYTHING on the
checklist.
DAILY START UP & MAINTENANCE (cont.)
MAINTENANCE
