Bandit
45
Copyright 12/17
MODELS 2890SP/2900T
Lead Tooth “Shorts” - Hex ..........900-9912-24
Lead Tooth “Shorts” - Square .....900-9909-96
Side Tooth “Longs” - Hex ............900-9912-23
Side Tooth “Longs” - Square .......900-9906-05
Pocket without locator pin - Hex ...900-9912-26
Pocket without locator pin - Square ...900-9909-98
Pocket with locator pin - Hex ......900-9912-25
Pocket with locator pin - Square ...900-9909-97
Tooth Nut ....................................900-9909-99
MAINTENANCE
NEW RIVER “REVOLUTION” CUTTER WHEEL
DANGER
!
NEVER USE HAND ON CUTTER WHEEL TO
HOLD IN PLACE WHILE CHANGING TEETH.
BE SURE TO REMOVE LOCKING PIN BEFORE
OPERATING THE MACHINE.
Do Not operate machine with extremely worn or
broken teeth.
Inspect teeth, nuts and pockets for damage and
replace as required.
When replacing teeth, always replace new teeth
across from each other (180°) in order to prevent
vibration.
Replacement teeth must be carbide tipped and of
like design as provided with the machine.
To make sure the correct tooth pattern is used, make
sure a pocket with a locator pin is used on a station
with a locator pin hole. Use the pockets without the
locator pin on a station without the locator pin hole.
When replacing complete set of teeth, be sure to
duplicate original factory tooth arrangement, with the
carbide tip facing the cutter wheel rotation. Typically
a 15/16” socket is required to change or torque the
teeth. Torque Lead Teeth to 200 ft.-lbs. (271 Nm) and
Side Teeth to 125 ft.-lbs. (169 Nm).
TOOTH ARRANGEMENT
A locking pin is provided to hold the cutter wheel
in position during tooth removal and reinstallation.
Locking pin will only lock on outer teeth.
There are thirty-two (32) teeth, thirty-two (32) tooth nuts, and twenty-four (24) pockets to a complete set.
Twenty-four (24) teeth: eight (8) lead teeth (Shorts) and twenty-four (24) side teeth (Longs). Twenty-four (24)
pockets: twelve (12) pockets without locator pin and twelve (12) pockets with locator pin.
Use only original equipment manufacturer’s teeth.
The use of any other aftermarket teeth may cause
damage or premature failure to the drive train.
DO NOT OPERATE MACHINE WITHOUT A
FULL SET OF TEETH. OPERATING MACHINE
WITHOUT A FULL SET OF TEETH CAN CAUSE
EXCESSIVE VIBRATION AND PREMATURE
BEARING FAILURE.
DANGER
!
Before attempting any type of maintenance,
disengage clutch or cutter wheel engagement, wait
for the cutter wheel to come to a complete stop,
position and lock the cutter wheel in the transport
position, turn off engine, remove the ignition key,
make sure the ignition key is in your possession,
install the cutter wheel lock pin, wait 2 minutes then
disconnect the battery.
DANGER
!
DO NOT go near the rotating cutter head for any
reason. DO NOT go near the cutter head while the
engine is running or the cutter head is coasting to a
stop. Contact with a rotating cutter head will result
in serious bodily injury or death.
DANGER
!
Lead
Teeth
Side
Teeth
