Bandit
31
Copyright 12/18
MODEL ZT1844
MAINTENANCE
1. Grease swing out console pivot with 1 - 2 shots.
2. Drain and clean the fuel tank.
3.
Change hydraulic oil and flush the hydraulic tank.
4. Replace hydraulic suction screen(s) annually or every 2000 hours.
YEARLY CHECK LIST
Every year these checks must be made:
OK REPAIRED
PAINT CARE
To help keep up the appearance of your Bandit equipment and reduce the possibility of surface rust follow
these steps:
1. The machine should be washed on a regular basis with a non-abrasive mild detergent and then rinsed
thoroughly.
Do not pressure wash sensitive areas
like: decals, gauges, electronic devices, autofeed
control, etc.
2. If a stone chip, paint scratch, or paint crack occurs - it should be repaired immediately. Simply sand the
edgesofthedamagedpaintarea,maskoffthesurroundingarea,andapplyprimerandpainttothedry,
clean, and warm area. This will keep the damaged area from spreading or getting worse.
3. If you are unable to sand and mask the area, there are containers of primer and paint available. A small
brush can be used to touch up the area.
4.
Also,primerandmostcolorsofpaintareavailableinaerosolspraycanstosimplysprayovertheeffected
area after it is cleaned, dry, and warmed. This method is not as reliable as the process in step #2.
Itisalsoreportedthatsomeequipmentownerspolishtheirmachineatleastyearly,andkeepgoodmudflaps
on their towing trucks.
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION
BOLT SIZE
TORQUE (FT.-LBS.) TORQUE (Nm)
Cutter Wheel Green Tooth Pocket Bolts
5/8” - 18 NF
180
244
Cutter Wheel Green Tooth Nut
7/16” - 14 NC
35
47
Cutter Wheel Sheave Bushing
3/8” - 16 NC
30
41
Jack Shaft Sheave Bushing - Cutter Wheel Side
3/8” - 16 NC
30
41
Jack Shaft Sheave Bushing - Engine Side
5/16” - 18 NC
15
20
Engine Sheave Bushing
3/8” - 16 NC
30
41
Hydraulic Pump Sheave Bushing
3/8” - 16 NC
30
41
Cutter Wheel Bearing Bolts
5/8” - 11 NC
80
108
Cutter Wheel Bearing Set Screws
57
77
Track Drive Sprocket
1/2” - 20 Lug Nut
90
122
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved teeth and hardware.
Summary of Contents for ZT1844
Page 7: ......
Page 21: ...Bandit 19 Copyright 12 18 MODEL ZT1844 7 8 9 10 11 15 CONTROLS CONTROLS COMPONENTS cont 16...
Page 59: ...Bandit 57 Copyright 12 18 MODEL ZT1844 SERVICE RECORD SERVICE RECORD DATE DESCRIPTION AMOUNT...
Page 60: ...Bandit 58 Copyright 12 18 MODEL ZT1844 SERVICE RECORD DATE DESCRIPTION AMOUNT SERVICE RECORD...