Bandit
33
Copyright 12/18
MODEL ZT1844
WearSharp Tooth ................................ 900-9926-71
WearSharp Tooth Nut ......................... 900-3937-58
Angle Pocket ...................................... 900-9907-86
Pocket Spacer .................................... 900-9938-57
Pocket Bolt w/ Spacers....................... 900-9916-03
Pocket Bolt w/o Spacers..................... 900-9907-42
8 Tooth Kit ........................................... 900-9938-33
MAINTENANCE
CUTTER WHEEL - GREEN TEETH
DO NOT operate machine without a full set of
teeth. Operating the machine without a full set of
teeth can cause excessive vibration and premature
bearing failure.
TOOTH ARRANGEMENT
Inspect pockets, teeth and bolts for damage and
replace as required.
When replacing pockets, always replace new
pockets across from each other (180°) in order to
prevent vibration.
Replacement teeth must be carbide tipped and of
like design as provided with the machine.
Use anti-seize on threads to help prevent bolts from
“freezing up” in cutter wheel pockets.
When replacing complete set of teeth, be sure to
duplicate original factory tooth arrangement, with
the carbide tip facing the cutter wheel rotation.
Typically a 1/2” allen key socket is required to
change or torque the teeth. Torque pocket bolts to
180 ft.-lbs. (244 Nm). Torque tooth nut to 35 ft.-lbs.
(47 Nm).
Inspect pockets, teeth and bolts for damage and
replace as required.
Each pocket requires an angle pocket mounted away
from the cutter wheel. Every other pocket requires an
additional spacer mounted between the angle pocket
and the cutter wheel on each side of the cutter wheel.
A locking pin is provided to hold the cutter wheel
in position during tooth removal and reinstallation.
Locking pin will only lock on outer teeth.
There are eight (8) teeth and eight (8) angle
pockets to a complete set.
DANGER
!
Use only original equipment manufacturer’s teeth.
The use of any other aftermarket teeth may cause
damage or premature failure to the drive train.
WARNING
!
Before attempting any type of maintenance,
disengage clutch or cutter wheel engagement, wait
for the cutter wheel to come to a complete stop,
position and lock the cutter wheel in the transport
position, turn off engine, remove the ignition key,
make sure the ignition key is in your possession,
disconnect the battery, and install the cutter wheel
lock pin.
DANGER
!
DO NOT go near the rotating cutter head for any
reason. DO NOT go near the cutter head while the
engine is running or the cutter head is coasting to a
stop. Contact with a rotating cutter head will result
in serious bodily injury or death.
DANGER
!
Never use hand on cutter wheel to hold in place
while changing teeth. Be sure to remove locking pin
before operating the machine.
DANGER
!
DO NOT operate machine with extremely worn or
broken teeth.
NOTICE
NOTICE
WARNING
!
When the tooth has 1/16” of wear on the carbide
tip, it is time to rotate or replace the tooth.
Summary of Contents for ZT1844
Page 7: ......
Page 21: ...Bandit 19 Copyright 12 18 MODEL ZT1844 7 8 9 10 11 15 CONTROLS CONTROLS COMPONENTS cont 16...
Page 59: ...Bandit 57 Copyright 12 18 MODEL ZT1844 SERVICE RECORD SERVICE RECORD DATE DESCRIPTION AMOUNT...
Page 60: ...Bandit 58 Copyright 12 18 MODEL ZT1844 SERVICE RECORD DATE DESCRIPTION AMOUNT SERVICE RECORD...