Bandit
43
Copyright 12/18
MODEL ZT1844
Insert Pressure
Check Gauge Here
Unhook this hose
andplugitoff
Beforeattemptinganyhydraulicpressuresettings,makesureengineisshutoff,enginekeyremovedandin
your possession, hydraulic oil is clean, hydraulic tank is 3/4 to 7/8 full, and the machine has been pre-run to
warm the hydraulic oil. To correctly check relief valve pressure, gauge MUST be installed correctly.
HYDRAULICS
WARNING
!
The relief valve is typically located internally in the valve bank. Do not adjust the relief valves above the
specifiedpsi(bar).Thereliefvalvesystemisasimplespringtensiondesignbutsmallpiecesofdebriscan
stick the valve partially open which weakens the hydraulic power. The relief as well as hydraulic oil, and
suction screen must be kept clean.
CHECKING HYDRAULIC PRESSURE
1. Makesureallthecontrolsareintheoffposition.
2. Install pressure gauge into the test port, see
below.
3. Start engine and adjust engine to full throttle.
4. Engage the control lever or switch so that the cylinder
of the function that needs to be checked, bottoms
out and then read the pressure gauge.
5. Adjust relief if necessary. Turn the relief clockwise
to increase pressure and counter- clockwise to
decrease the pressure.
Track
Relief
Cutter Head Swing Left/Right &
Cutter Head Up/Down Relief
1. Makesureallthecontrolsareintheoffposition.
2 Swing the console to the right side, and place a
drip pan below.
3. Unhook the Right Track B-Port hose and plug it
off.
3. Install pressure gauge into the test port, see below.
4. Start engine and adjust engine to full throttle.
5. Engage the Right Track in the forward position
and read the pressure gauge.
6. Adjust relief if necessary. Turn the relief clockwise
to increase pressure and counter- clockwise to
decrease the pressure.
CUTTER HEAD LEFT/RIGHT &
UP/DOWN PROCEDURES
RIGHT & LEFT TRACK
PROCEDURES
Summary of Contents for ZT1844
Page 7: ......
Page 21: ...Bandit 19 Copyright 12 18 MODEL ZT1844 7 8 9 10 11 15 CONTROLS CONTROLS COMPONENTS cont 16...
Page 59: ...Bandit 57 Copyright 12 18 MODEL ZT1844 SERVICE RECORD SERVICE RECORD DATE DESCRIPTION AMOUNT...
Page 60: ...Bandit 58 Copyright 12 18 MODEL ZT1844 SERVICE RECORD DATE DESCRIPTION AMOUNT SERVICE RECORD...