Using Your Remote
15
4.
Press and hold the button on the original remote control that you wish to
teach into the AV7.1, for approximately three seconds. The LCD on the
AV7.1 will show - - - - - indicating that it is receiving information from
the original remote control.
5.
Release the button on the original remote control. The LCD on the
AV7.1 will show RETRY.
6.
Press and hold the same button on the original remote again, for
approximately three seconds. The LCD on the AV7.1 will flash GOOD,
the Device Mode and then return to LEARN, verifying that the new
function has been learned.
Repeat steps 3 through 6 for any other Device buttons you wish to teach new
functions.
7.
Once you have completed the learning for all of the desired Device
buttons, store the learned functions by pressing the B&K and SEL /
PLAY buttons simultaneously, once again. The LCD in the AV7.1 will
show SAVED and then return to the B&K mode. The remote control
has now returned to the original operating mode.
Erasing Learned Functions
To erase learned functions, please refer to the following procedures:
Erasing Individual Buttons:
1.
Press the Device button for the mode where the learned function has
been stored.
2.
Press and hold the Device and SEL / PLAY buttons simultaneously, for
approximately three seconds, until the LCD shows LEARN.
3.
Press and release the button to be erased. The LCD will show READY.
4.
Press the LIGHT button. The LCD will flash ERASE, CLEAR, Device
Mode, and then return to LEARN. Repeat Steps 3 and 4 for any other
buttons to be erased.
5.
Return to the normal operating mode, by pressing the Device and the
SEL / PLAY buttons simultaneously.
The learned functions on the selected buttons have now been erased. The
default preprogrammed functions for these buttons will now operate on the
remote control.
Summary of Contents for AV7.1
Page 1: ...B K AV7 1 Preprogrammed Learning Remote Control...
Page 2: ......
Page 6: ...Using Your Remote 4 A Function Table Reference...
Page 49: ......
