55
ZONE ‘Z’
Use the Z (zone) function via the remote control
- For use in a second audio zone, your receiver comes
equipped with a fully independent 2-channel analog pre-amp. The easiest way to control this second zone is with
a dedicated Zone 2 (the factory default zone ID setting of Zone B is 2) remote available from B&K and other
universal remote suppliers. However, you may also control your unit’s second zone from the Zone 1 remote via its
“Z” button.
From Remote
From Front Panel
Action
1
B&K
make sure remote is in B&K mode
2
Z
select alternate zone control
3
2
select desired zone
Normally, your second zones’ zone ID will be set to 2. However, because it is possible to change the zone ID,
(see Advanced settings) enter the current Zone B zone ID here to get control of the second zone. If the zone ID is
10 or larger hit +10 followed by the second digit to gain control.
After a few seconds of inactivity, control will automatically revert to Zone 1. If you don’t wish to wait, just press Z
then 1. You may also control Zone 2 from a remote control or front panel via the menu system. See Zone 2
operation
PRESETS
Presets allow you to save your favorite settings and recall them instantly. Your receiver can store two banks of 40
presets (0...39) in each of 2 Zones. The saved information includes the selected audio source, selected video
source, volume, the audio mode and number of speakers, the tuner station and band settings, and all of the
temporary settings and overrides described previously. A convenient set of 10 presets come preprogrammed with
your receiver.
Recalling a Preset
From Remote
From Front Panel
Action
1
number or +10 + number
(PRESET) step favorite preset
review settings for recall
2
SEL or ENTER
(ENTER)
recall preset
CONTROL ZONE 2
Control Zone 2
+10 0-9 to select zone
RECALL PRESET 2
DVD -25 dB
Source DVD Record DVD
Video DVD Volume - 25.0
Mode Surround Center 0.0
Spkrs 7 Rear 0.0
Eq 0 Off Sub 0.0
0..9 +10 preset SEL confirm
MENU cancel
2 DVD - 25 DB
