Source Levels
This setup allows you to match the levels of your sources so that there are no large changes in volume as you
change from one source to another. This is for your convenience only and need not be performed unless you wish
to. You may use a SPL meter or your ear to adjust the levels. Note that the levels will depend not only on this
setting but also on the source material being played back. You may wish to use a test disc. Make sure you are in
the SETUP MENUS and your remote is in AUDIO mode.
S O U R C E L E V E L
DEFAULT USER LEVEL
9
9&5
GE
change position
previous page
←→
M E N U
V1
VCR 0.0 dB
A U D
to select control
select source to rename
Using AV system controller
S E T U P M E N U S
1 Speaker Size and Delay
2 Speaker Calibration
3 Source Levels
4 AM Tuner Channels
6285&( /(9(/6
move to new line
select menu page
previous page
↑ ↓
SEL
M E N U
5 FM Tuner Channels
return to SETUP MENUS
MENU
MENU
7
adjust more sources
repeat 3 - 5
repeat 3 - 5
6
adjust source level
VOLUME KNOB
(REW) or
(FF)
5
return control to A/V System Controller
AUDIO
4
select source to adjust
(SOURCE) step to source
desired source
3
activate SOURCE LEVEL
↵
(ENTER)
SEL or ENTER
2
move to Source Levels
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
1
Action
From Front Panel
From Remote
AM Tuner Settings
This set up allows you to preset up to 20 AM tuner channels for fast access. This is for your convenience only and
need not be performed unless you wish to.
Manual Tuning - Quick presses of LEFT/RIGHT or turn and release of the VOLUME KNOB will cause tuning in
single 10 kHz steps. (9kHz steps for European version.)
Seek Tuning - Holding LEFT/RIGHT or VOLUME will cause the tuner to SEEK (tune up or down automatically
stopping on strong stations). Once the tuner has started seeking you can let go of the button/knob. Once a station
is found you must let go of the button/knob before you can change frequencies again. In strong signal areas the
tuner may stop one step above or below the true frequency. Unless you are sure of the station’s frequency, check
to see that the signal might be better one step above or below the frequency that SEEK has found. In weak signal
areas the tuner may continue to seek all the way to the end of the band. To stop this simply press the ARROW (or
turn the VOLUME KNOB) in the opposite direction.
29
p/n 12698 Rev. 9808B
