ZONE CONFIGURATION
Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID codes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.
Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. This is very useful if you are
using speakers that can’t handle the maximum power output from your A/V System Controller or if you simply wish
to limit the volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the A/V System Controller may appear broken (no sound).
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
= 0$; /9/
move to new line
previous page
↑ ↓
M E N U
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
=21( 6(783
move to new line
previous page
↑ ↓
M E N U
select menu page
SEL
3 Control Out
4 Security Options
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter
←→
set desired maximum level
VOLUME KNOB
(REW) or
(FF)
4
move to Z1 Max Level
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
3
activate ADVANCED ZONE SETTINGS
↵
(ENTER)
SEL or ENTER
2
move to Zone Configuration
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
1
Action
From Front Panel
From Remote
40
p/n 12698 Rev. 9808B
