34
FPLMP138
FPLMP138
In
more
detail
. . .
Mowing
1. Make sure that the lawn is clear of stones, sticks, wires or other objects that could
damage the product or its engine.
2. Do not cut wet grass because it tends to stick to the underbody of the product,
preventing the proper discharge of grass clippings, and it could also cause you to
slip and fall.
3. Never cut off more than one-third of the total length of the grass for a healthy lawn.
In the autumn, lawns should only be cut as long as there is growth.
4. Slowly push the product forward. Use the self-propelled
function for assistance.
5. Mow in slightly overlapping rows. The most effective
pattern for mowing lawns is straight lines along one of
the sides. This keeps the rows even and ensures that all
the lawn is cut without missing any spots (Fig.
19
).
6. Circle around flower beds. When reaching a flower bed
in the middle of the lawn, cut a row or two around the
circumference of the bed.
7. Pay particular attention when changing direction.
8. Empty the grass catcher (
22
) regularly.
WARNING!
Extensive vibration of the product during operation is an indication
of damage! Stop the engine immediately. The product should be promptly
inspected and repaired!
After use
1. Stop the engine, disconnect the spark plug connector (
14
) and let the product cool.
2. Check, clean and store the product as described below.
The golden rules for care
DANGER!
Proper maintenance is essential for safe and trouble free operation.
Improper maintenance, or failure to address a problem instantly can cause a
malfunction which can result in serious injury or even death.
19
WARNING!
Stop the engine, disconnect the spark plug connector (
14
) and let
the product cool before performing inspection, maintenance and cleaning work!
Do not touch the rotating blade (
26
).
1. Keep the product clean. Remove debris after each use and before storage.
2. Regular and proper cleaning helps to ensure safe operation and prolongs the life
of the product.
3. Inspect the product before each use for worn and damaged parts. Do not operate
it if you find broken and worn parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
WARNING!
Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!
Cleaning
1. Clean the product with a slightly damp cloth and mild soap. Use a brush for areas
that are hard to reach.
2. In particular, clean the air vents (
10
) after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max.
3
bar).
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its surfaces.
Maintenance
Before and after each use, check the product and accessories for wear and damage. If
required, exchange them for new ones as described in this instruction manual. Observe
the technical requirements.
WARNING!
It is required to tip the product when performing the maintenance.
The fuel tank (
9
) must be empty, or fuel can leak which could result in fire or
explosion.
NOTE:
Always empty the fuel tank (
9
) and keep the spark plug (
14a
) upside
down. Otherwise, the fuel or engine oil might contaminate the air filter (
12a
)/
spark plug (
14a
) and might make it difficult start the engine.
Operation/Care and maintenance
3663602423287-GB-V04.indd 34
27/9/2018 14:55
