29
NMLM1000
In
more
detail . . .
Trouble shooting
Suspected malfunctions are often due to causes that the user can fix themselves .
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING!
Only perform the steps described within these instructions! All
further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualified specialist if you cannot solve
the problem yourself!
Problem
Possible cause
Solution
1. Product does not
start
1.1 Not connected to
power supply
1.2 Power cord or plug is
defective
1.3 Other electrical defect
to the product
1.4 Lock-off button not
pressed
1.1 Connect to power supply
1.2 Check by a specialist
electrician
1.3 Check by a specialist
electrician
1.4 Press the lock-off button
then the start lever
2. Product does not
reach full power
2.1 Extension cord not
suitable for operation
with this product
2.2 Power source (e.g.
generator) has too low
a voltage
2.3 Air vents are blocked
2.1 Use a suitable extension
cord
2.2 Connect to another
power source
2.3 Clean the air vents
3. Unsatisfactory result
3.1 Cutting device is worn
3.2 Cutting material
exceeds capacity
3.3 Cutting height is
incorrect
3.1 Replace with a new one
3.2 Only cut materials
according to capacity of
the product
3.3 Adjust cutting height with
the lever
Trouble shooting
