X20 system modules • Digital output modules • X20DOD322
X20 system User's Manual 3.10
1297
4.15.29 X20DOD322
4.15.29.1 General information
The X20DOD322 module is equipped with eight outputs for 1-wire or 2-wire connections. The X20DOD322 is
designed for source output wiring.
•
8 digital outputs
•
Source connection
•
2-wire connections
•
GND for signal supply
•
Integrated output protection
4.15.29.2 Order data
Model number
Short description
Figure
Digital output modules
X20DOD322
X20 digital output module, 8 outputs, 24 VDC, 0.5 A, source, 2-
wire connections
Required accessories
Bus modules
X20BM11
Bus module, 24 VDC keyed, internal I/O supply continuous
Terminal blocks
X20TB1F
X20 terminal block, 16-pin, 24 VDC keyed
Table 416: X20DOD322 - Order data
4.15.29.3 Technical data
Product ID
X20DOD322
Short description
I/O module
8 digital outputs 24 VDC for 1- or 2-wire connections
General information
B&R ID code
0xC0E9
Status indicators
I/O function per channel, operating state, module status
Diagnostics
Module run/error
Yes, using status LED and software
Outputs
Yes, with status LED and software status (output error status)
Power consumption
Bus
0.19 W
Internal I/O
0.8 W
Additional power dissipation caused by the actua-
tors (resistive) [W]
1)
0.28 W
Electrical isolation
Channel - Bus
Yes
Channel - Channel
No
Certification
CE
Yes
cULus
Yes
ATEX Zone 2
Yes
KC
Yes
GOST-R
In preparation
Digital outputs
Design
FET positive switching
Nominal voltage
24 VDC
Switching voltage
24 VDC -15% / +20%
Nominal output current
0.5 A
Total nominal current
4.0 A
Connection type
1- or 2-wire connections
Output circuit
Source
Output protection
Thermal cutoff for overcurrent or short circuit (see value "Peak short circuit current")
Internal inverse diode for switching ind. loads (see section "Switching inductive loads")
Diagnostic status
Output monitoring with 10 ms delay
Table 417: X20DOD322 - Technical data
Summary of Contents for X20 System
Page 2: ......
