Mechanical handling
X20 system User's Manual 3.10
2687
7.8.2 Labeling the terminals
To prevent errors, the X20 terminal blocks can be coded. This helps prevent terminal blocks from being inserted
in the wrong electronic module.
Figure 860: Terminal coding helps prevent errors from the start.
1. Grip the desired label tag with the single-width cutters of the labeling tool (compare with section 7.8.1 "Labeling
2. Center the label tag over the slot on the electronic module.
Figure 861: Center the label tag over the slot on the electronic module
3. Hold the labeling tool at a 90° angle to the electronic module and press to insert the label's feet into the slot.
4. Remove a label tag with the single-width cutter of the labeling tool.
5. Set the label tag in the slot on the back of the terminal block as shown.
Figure 862: Set the label tag in the slot on the back of the terminal block
Summary of Contents for X20 System
Page 2: ......