X20 system modules • Analog input modules • X20AP31x1
X20 system User's Manual 3.10
341
4.3.14.10.10.5 Reverse active energy on phase A/B/C
Name:
ANenergyA
ANenergyB
ANenergyC
Active energy in reverse direction of the phase.
Data type
Value
Information
UDINT
0 to 4,294,967,295
Resolution 0.1 or 0.01 CF, depending on the Power Line factor (e.g. kWs)
Comments:
•
The unit CF is derived from the Power Line factor (default: 3600 Imp/kWh), see register "MeteringMode"
•
The resolution can be switched between 0.1 and 0.01, see register "MeteringMode"
•
The register is updated automatically after being enabled, see register "ControlOutput" <Bit 1>
•
The register is cleared upon request, see register "ControlOutput"
•
The register is set upon request, see register "ControlOutput" <Bit 3>
4.3.14.10.10.6 Forward total reactive energy
Name:
RPenergyT
Total reactive energy in forward direction.
Data type
Value
Information
UDINT
0 to 4,294,967,295
Resolution 0.1 or 0.01 CF, depending on the Power Line factor (e.g. kWs)
Comments:
•
The unit CF is derived from the Power Line factor (default: 3600 Imp/kWh), see register "MeteringMode"
•
The resolution can be switched between 0.1 and 0.01, see register "MeteringMode"
•
The register is updated automatically after being enabled, see register "ControlOutput" <Bit 1>
•
The register is cleared upon request, see register "ControlOutput"
•
The register is set upon request, see register "ControlOutput" <Bit 3>
4.3.14.10.10.7 Forward reactive energy on phase A/B/C
Name:
RPenergyA
RPenergyB
RPenergyC
Reactive energy in forward direction of the phase.
Data type
Value
Information
UDINT
0 to 4,294,967,295
Resolution 0.1 or 0.01 CF, depending on the Power Line factor (e.g. kWs)
Comments:
•
The unit CF is derived from the Power Line factor (default: 3600 Imp/kWh), see register "MeteringMode"
•
The resolution can be switched between 0.1 and 0.01, see register "MeteringMode"
•
The register is updated automatically after being enabled, see register "ControlOutput" <Bit 1>
•
The register is cleared upon request, see register "ControlOutput"
•
The register is set upon request, see register "ControlOutput" <Bit 3>
Summary of Contents for X20 System
Page 2: ......
