X20 system modules • X20 interface module communication • X20IF10A1-1
X20 system User's Manual 3.10
1833
4.23.18 X20IF10A1-1
4.23.18.1 General information
The interface module is equipped with an AS master interface. It can be operated in X20 CPUs or in the expandable
X20BC1083 POWERLINK bus controller.
AS-i stands for actuator-sensor interface and is a bus system for the lowest field level of automation technology.
Using AS-i bus systems provides an easy and affordable way to connect, operate and service sensors and actu-
ators.
This eliminates the need for parallel wiring, where each individual sensor or actuator was connected to the input or
output module via a separate wire. A dual-core wire is used instead, which transfers both power and information
at the same time.
•
AS interface master
•
Electrically isolated
•
4-pin bus connector
4.23.18.2 Order data
Model number
Short description
Figure
X20 interface module communication
X20IF10A1-1
X20 interface module, for DTM configuration, 1 ASi master in-
terface, electrically isolated, order 1x TB704 terminal block sep-
arately.
Required accessories
Terminal blocks
0TB704.9
Accessory terminal block, 4-pin, screw clamps 2.5 mm²
0TB704.91
Accessory terminal block, 4-pin, cage clamps 2.5 mm²
Table 624: X20IF10A1-1 - Order data
Summary of Contents for X20 System
Page 2: ......
