Standards and certifications
2690
X20 system User's Manual 3.10
8.2 Certifications
Products and services from B&R comply with applicable standards. They are international standards from organi-
zations such as ISO, IEC and CENELEC, as well as national standards from organizations such as UL, CSA, GL,
VDE, ÖVE, etc. We place special focus on the reliability of our products in an industrial environment.
Information:
The certifications that apply to a particular module can be found in the following locations:
•
On the data sheet, in the "Technical data" table under "General information / Certification".
•
, select the module under "Products", under "Specifications" in the
"Certification" section
•
On the side of the module housing
UL certification
Products with this mark have been tested by Underwriters Laboratories and are listed
as "Industrial Control Equipment". This mark is valid for the USA and Canada and
simplifies the certification of your machines and systems in these areas.
Underwriters Laboratories (UL) in accordance with the UL508 standard - 17th Edition
Canadian (CSA) standard in accordance with C22.2 No. 142-M1987
CSA
Hazardous Locations
Products with this mark have been certified by the Canadian Standard Association
and are suitable for use in potentially explosive environments. The X20 system is
certified for Hazardous Locations Class I Division 2.
Each module is accompanied by an information sheet providing detailed installation
and safety guidelines. This mark is valid for the USA and Canada and simplifies the
certification of your machines and systems in these areas.
Functional safety
Products with this mark were designed, developed and manufactured for special ap-
plications for machine and personnel protection. The products are certified by the
recognized authorities (TÜV Rheinland, TÜV Süd, Underwriters Laboratories), and
satisfy the requirements of international safety standards ISO 13849, IEC 62061,
IEC 61511 and IEC 61508.
GL certification (Germanischer Lloyd)
Many B&R products are certified by Germanischer Lloyd and suitable for use in mar-
itime environments. GL certificates (type approval) are generally accepted by other
classification societies during ship acceptance procedures.
Germanischer Lloyd (GL) in accordance with standard GL VI-7-2 (2012) (Categories
B and D, each EMC1)
ATEX
Products with this mark have been tested by an accredited testing laboratory and are
suitable for use in potentially explosive environments.
The X20 system is certified for use in environments with explosive gases with a nor-
mal level of safety in Zone 2.
Each module is accompanied by an information sheet providing detailed installation
and safety guidelines.
Summary of Contents for X20 System
Page 2: ......
