Technical data • Complete system
Chapter 2
Technical data
Panel PC 2100 swing arm user's manual V1.12
39
2.4.3 Ethernet 1 interface (ETH1)
This Ethernet controller is connected to external devices via the system unit.
Ethernet 1 interface (ETH1
1)
)
Controller
Intel I210
Cabling
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
Speed LED
On
Off
Yellow
100 Mbit/s
10 Mbit/s
3)
Green
1000 Mbit/s
-
Link LED
On
Off
Green
Link (connection to an
Ethernet network exists)
Activity (blinking - da-
ta transfer in progress)
RJ45, female
Table 25: Ethernet interface (ETH1)
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer speed / connection only exists if the Link LED is also lit at the same time.
Driver support
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
in the Downloads section of the B&R website (
Information:
Required drivers must be downloaded from the B&R website only, not from manufacturer websites.
2.4.4 Ethernet 2 interface (ETH2)
This Ethernet controller is connected to external devices via the system unit.
Ethernet 2 interface (ETH2
1)
)
Controller
Intel I210
Cabling
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
Speed LED
On
Off
Yellow
100 Mbit/s
10 Mbit/s
3)
Green
1000 Mbit/s
-
Link LED
On
Off
Green
Link (connection to an
Ethernet network exists)
Activity (blinking - da-
ta transfer in progress)
RJ45, female
Table 26: Ethernet interface (ETH2)
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer speed / connection only exists if the Link LED is also lit at the same time.
Driver support
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
in the Downloads section of the B&R website (
Information:
Required drivers must be downloaded from the B&R website only, not from manufacturer websites.
