Technical data
124
Automation Panel 5000 User's manual V2.11
4.2.4.2 5ACCFL00.0100-000
4.2.4.2.1 General information
The swivel-tilt flange is installed on the mounting unit and designed for swing arm systems with 48 mm shaft
diameter. The range of rotation is from -150° to +150°; the tilting range is up to a maximum of 15°.
•
Swivel-tilt flange
•
Range of rotation: ±150°
•
Tilting range: ±15°
•
Stepless adjustment of the range of rotation and tilting range
•
For swing arm systems with 48 mm shaft diameter
•
Tightening torque for tilt flange locking lever: Max. 7 Nm
•
Tightening torque rotary flange locking lever: 5 Nm
•
Tightening torque for locking screw (M6) opposite the clamping lever: Max. 3 Nm
Warning!
The swivel-tilt flange is generally compatible with all panel sizes.
Use in conjunction with panels in portrait format is not recommended since the range of rotation and
tilt cannot be fully utilized.
Caution!
After adjusting the rotation and/or tilt angle, the corresponding locking lever must be fixed in position
(see above for the maximum tightening torques).
The screw in the locking lever is not permitted to be tightened. Fixing must be carried out exclusively
with the locking lever.
4.2.4.2.2 Order data
Model number
Short description
Figure
Flange
5ACCFL00.0100-000
AP5000 flange - Swivel-tilt flange for swing arm - For swing arm
mounting unit
Table 53: 5ACCFL00.0100-000 - Order data
4.2.4.2.3 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for these individual
components and may differ from those of the complete system. The data specified for the complete
system applies to the complete system in which this individual component is used, for example.
Model number
5ACCFL00.0100-000
General information
Certifications
CE
Yes
EAC
Product family certification
UL
cULus E115267
Industrial control equipment
Table 54: 5ACCFL00.0100-000 - Technical data
