Technical data
130
Automation Panel 5000 User's manual V2.11
Model number
5ACCKP01.156B-000 5ACCKP01.185B-000 5ACCKP01.215C-000 5ACCKP01.215I-000 5ACCKP01.240C-000
Selector switch
Quantity
1
Type
RAFIX 22 FS+, 1.30.272.102/2200
Contact element
Maintained
Key switch
Quantity
1
Type
RAFIX 22 FS 1.30.255.222/0000
Contact element
Maintained
Emergency stop
Quantity
1
Type
RAFIX 22 FS+, Plus 1, 1.30.273.512/0300
Contact element
Maintained
Operating conditions
Pollution degree per EN 61131-2
Pollution degree 2
Mechanical properties
Material
Steel sheet
Weight
800 g
900 g
1000 g
700 g
1100 g
Table 60: 5ACCKP01.156B-000, 5ACCKP01.185B-000, 5ACCK-
P01.215C-000, 5ACCKP01.215I-000, 5ACCKP01.240C-000 - Technical data
4.2.5.2.4 USB interface
The expansion unit is equipped with a USB 2.0 interface. This is equipped with a protective cover.
Caution!
IP65 protection can only be achieved if the USB protective cover is properly installed.
Warning!
USB peripheral devices can be connected to the USB interfaces. Due to the variety of USB devices
available on the market, B&R cannot guarantee their functionality. The functionality of USB devices
available from B&R is guaranteed.
Caution!
Due to the general PC specification, this interface must be handled with the utmost care with regard
to EMC, cable routing, etc.
The USB interface is internally connected to the system via USB 2.0 and available to the user for service purposes.
Depending on the transfer method (SDL, DVI, SDL3 or SDL4 operation), there may be limitations with regard to the
transfer rate of the USB interfaces. For possible transfer methods, see section
"Connection options" on page 21
Transfer method
USB type
Max. cable length
SDL operation without USB cable
USB 1.1
25 m
1)
SDL operation with USB cable
USB 2.0
5 m
Single-touch DVI operation
USB 2.0
5 m
Multi-touch DVI operation
USB 2.0
5 m
SDL3 operation
USB 2.0
100 m
SDL4 operation
USB 2.0
100 m
1)
The max. cable length of 25 m depends on the resolution. For exact specifications, see table
" in the AP5000 user's manual.
Front USB of the expansion unit
1)
Standard
USB 2.0
Variant
Type A, female
Low speed (1.5 Mbit/s)
Full speed (12 Mbit/s)
Transfer rate
High speed (480 Mbit/s)
2)
Current-carrying capacity
3)
Max. 0.5 A
Cable length
USB 2.0
<3 m (without hub)
-
1)
The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2)
In SDL operation without USB cable (mode 1), the USB transfer rate is limited to USB 1.1.
In SDL3 operation: Low speed (1.5 Mbit/s), full speed (12 Mbit/s) to high speed (30 Mbit/s)
In SDL4 operation: Low speed (1.5 Mbit/s), full speed (12 Mbit/s) to high speed (150 Mbit/s)
3)
The USB interface is protected by a maintenance-free "USB current-limiting switch" (max. 0.5 A).
