Technical data • Complete system
28
Automation Panel 9x3 User's Manual V1.00
2.5.3 Panel In interface
SDL or DVI transfers are possible using the Panel In interface. For more information, see "SDL operating mode"
on page 14 and "DVI operating mode" on page 15.
Panel In interface - SDL (Smart Display Link) / DVI
The following overview lists the video signals available on the panel input. For addition-
al details, see the technical data for the link module or display unit being used.
Link module
Video signals
5DLSDL.1001-00
SDL, DVI
Table 22: Panel In interface - SDL, DVI
Information:
The hardware and graphics drivers of approved operating systems support the hot-plugging of display
devices to the panel interface for service purposes. The male panel connector is specified for 100
connection cycles.
Information:
If a display device with a touch screen is connected to the panel interface and then disconnected again
during operation (hot-plugging), it may be necessary to recalibrate the touch screen.
2.5.3.1 Pinout
Pin Assignment
Description
Pin Assignment
Description
1 TMDS data 2-
DVI lane 2 (negative)
16 HPD
Hot plug detect
2 TMDS data 2+
DVI lane 2 (positive)
17 TMDS data 0-
DVI lane 0 (negative)
3 TMDS data 2/4
SHIELD
Shield for data pair 2 and 4
18 TMDS data 0+
DVI lane 0 (positive)
4 SDL-
SDL lane (negative)
19 TMDS Data 0/
XUSB1 SHIELD
Shield for data pair 0 and
USB1
5 SDL+
SDL lane (positive)
20 XUSB1-
USB lane 1 (negative)
6 DDC clock
DDC-based control signal
(clock)
21 XUSB1+
USB lane 1 (positive)
7 DDC data
DDC-based control signal
(data)
22 TMDS clock
shield
Shield for clock pair
8 NC
Not connected
23 TMDS clock+
DVI clock (positive)
9 TMDS data 1-
DVI lane 1 (negative)
24 TMDS clock -
DVI clock (negative)
10 TMDS DATA 1+ DVI lane 1 (negative) HDMI
clock (positive)
C1 NC
Not connected
11 TMDS DATA 1/
XUSB0 SHIELD
Shield for data pair 1 and
USB0
c2 NC
Not connected
12 XUSB0-
USB lane 0 (negative)
C3 NC
Not connected
13 XUSB0+
USB lane 0 (positive)
C4 NC
Not connected
14 +5 V power
+5 V power supply
C5 NC
Not connected
15
Ground (return
for +5 V, HSync
and VSync)
Ground
DVI 24-pin, female
6 7 8
5
1 2 3 4
14 15 16
13
9 10 11 12
22 23 24
21
17 18 19 20
c1
c4
c2
c3
c5
Table 23: DVI interface - Pinout
2.5.3.2 USB transfer rates in SDL and DVI modes
Information:
In SDL mode, the USB transfer rate is limited to USB 1.1.
In DVI mode, the maximum USB transfer rate is determined by the USB interface and USB hub on the
industrial PC.
