4
PLACING OF PLATES FOR MAGNETICAL LIMIT SWITCHES
1.
Plate L.S. in closing (Fig 6). Position the gate in complete
closing, place the magnet at the centre of the buttonhole
and sold it to the rack in central direction of the group “Limit
switch”.
2.
Plate L.S. in opening (Fig 7). Position the gate in complete
opening, place the magnet at the centre of the buttonhole
and sold it to the rack in central direction of the group “Limit
switch”.
PLACING OF PLATES FOR MECHANICAL LIMIT SWITCHES
1.
Plate L.S. in closing (Fig 9). Position the gate in complete
closing and sold the stirrups at the centre of the group limit
switches. Therefore fix the slide in the appropriate plate
hole. (Fig 8).
2.
Plate L.S. in opening (Fig 9). Position the gate in complete
opening and sold the stirrups at the centre of the group
limit switches. Therefore fix the slide in the appropriate
plate hole. (Fig 8). (Fig 8).
USAGE
It is forbidden to use the motor for different purposes. The control
panel installed, that must have the electronic power regulation, allows
to select the functioning:
AUTOMATIC
: an impulse of command executes the opening and
the closing of the gate;
SEMI-AUTOMATIC
: an impulse of command execute the opening
or the closing of the gate.
In case of energy lack, act on the manual unlocking device and move
the gate manually. Please remember that we are in the presence of
an automatic device feed with electric energy so therefore used with
all the precaution. In particular is exhorted to:
don’t touch the device with wet hands and or with wet or naked
foots;
Cut the energy before opening the command box or then piston;
don’t pull the feeding cable to disconnect the plug;
Allow to move the gate only when completely visible;
Stay out of the action range of the gate, if this is in movement: wait
until it’s completely stopped;
don’t let the children or the animal play in the proximity of the gate;
don’t let the children use the remote controls or the other
commands of the gate;
do a periodical maintenance;
In case of damages, cut the energy and move the gate manually
only if possible and safe. Don’t do any intervention but call
specialized stuff.
MAINTENANCE
The motor gear MC4 is provided by a permanent lubrication with
grease so it doesn’t need of any maintenance: nevertheless his good
functioning depends also to the state of the gate, therefore we will
describe some operations in order to have always an efficient gate.
Warning: none apart the maintainer, that must be a specialized
technicians, could operate the gate in automatic during the
maintenance. It is suggested therefore to cut electric energy, avoiding
also electric shocks. If, otherwise, the energy must be present for any
possible need, is recommended to check or deactivate any command
device (remote controls, pushbuttons, etc).
ORDINARY MAINTENANCE:
Each one of the following operations
must be done when we realize the need and in any case every 6
months.
1)
Mechanic maintenance
Clean from debris the rail ant the relatives wheels;
Check the good functioning of the motor and the relative plate;
do an unlocking maneuver in order to be sure that the
mechanism will always be efficient.
2)
Electric maintenance
Check the good state of the safety devices;;
Check the efficiency of the electronic power regulation
Check the efficiency of the ground system. Test the differential
switch one time per month, pushing the test button on the
switch.
USAGE OF THE MANUAL RELEASE
In case it necessary to manually move the gate, cause a black
out or damages to the automation, it is necessary to use the
manual release system, as follows:
Open the cover using the personalized key and pull down the lever.
To lock again the system, put the lever in the original position and lock
the cover with the key.
