Commissioning
38
Mobile Panel 7200 User's manual V 1.01
3.2 Attachment shaft
Legend
1
Ethernet connection - Communication interface
2
Multipoint connector - Main connection for power supply and control lines
3.3 Cable installation
This section describes all the necessary procedures for installing a attachment cable for the Mobile Panel 7200
(see
"Attachment cables" on page 26
To install an attachment cable, the MP7200 must be placed with the display facing downwards. The surface used
for this must therefore be flat, clean and as soft as possible to avoid damaging the device.
Necessary support and tools
•
Torx 10 screwdriver
•
Wrench, hex-head 19
1. Loosen the orange highlighted screws on the cover plate (Torx 10).
2. Open the cover. Proceed with caution in order to avoid damaging the cables of the enabling control device.