Appendix A • Mounting compatibility
294
Power Panel 500 user's manual V1.40
302 x 187
6.5
6.5
6.5
6.5
PP100/200/300/400
Outer contour of device
Cutout for device
289 x 174
PP500
Figure 170: Mounting compatibility - 5.7" device - Horizontal2
5.7" Power Panel 500 devices and Power Panel 100/200300/400 devices are 100% mounting compatible in the
Horizontal2 format.
Outer contour of device
Cutout for PP100/200/300/400 device
6.5
11.7 PP100/200/300/400
6.5
6.5
212 x 245
PP100/200/300/400
Cutout for - PP500/AP1000 device
199 x 226.8
199 x 232
PP500
5.2
AP1000
6.5 PP500, AP1000
Figure 171: Mounting compatibility - 5.7" device - Vertical1
5.7" Automation Panel 1000 and Power Panel 500 devices are not 100% mounting compatible with Power Panel
100/200/300/400 devices in the Vertical1 format. Automation Panel 1000 and Power Panel 500 devices require a
cutout that is 5.2 mm higher (bottom edge).
The larger cutout can be used for all devices under certain conditions:
•
When mounting, make sure that the PP100/200/300/400 devices are placed and mounted as close to the
center of the cutout as possible. Failure to do so can prevent the retaining clips from holding firmly, which
means that a firm seal is no longer guaranteed with the gasket (IP65).
