Appendix A • Mounting compatibility
296
Power Panel 500 user's manual V1.40
Outer contour of device
Cutout for PP100/200/300/400 device
PP100/200/300/400
AP900/PPC700
13.5 PP100/200/300/400
323 x 358
8.5 AP900, AP1000, PPC700, PP500
8.5
10
10
303 x 341
303 x 336
Cutout for AP900/AP1000/PPC700/PP500 device
5
PP500
AP1000
Figure 174: Mounting compatibility - 10.4" device - Vertical1
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700 and Power Panel 500 devices are not 100%
mounting compatible with Power Panel 100/200/300/400 devices in Vertical1 format. Automation Panel 1000, Au-
tomation Panel 900, Panel PC 700 and Power Panel 500 devices require a cutout that is 5 mm higher (bottom edge).
The larger cutout can be used for all devices under certain conditions:
•
When mounting, make sure that the PP100/200/300/400 devices are placed and mounted as close to the
center of the cutout as possible. Failure to do so can prevent the retaining clips from holding firmly, which
means that a firm seal is no longer guaranteed with the gasket (IP65).
