Installation • Installation
128
Power Panel 500 user's manual V1.40
Chapter 3 • Installation
1 Installation
Danger!
•
All supplied power must be disconnected before removing device covers or components or
installing/removing accessories, hardware or cables.
•
The power cable must be disconnected from the device and from the voltage supply.
•
All covers, components, accessories, hardware and cables must be installed or connected be-
fore the device can be connected to the power supply and turned on.
B&R Industrial PCs are best mounted in a wall cutout using the retaining clips or clamping blocks found on the
housing (designs may vary).
1.1 Important installation information
•
Environmental conditions must be taken into consideration.
•
When installed in an enclosure, enough space must be available for air to circulate sufficiently.
•
This device must be installed on a flat, clean and burr-free surface.
•
This device is only certified for operation in enclosed rooms.
•
This device must not be subjected to direct sunlight.
•
Ventilation holes must not be covered.
•
This device must be installed using one of the approved mounting orientations.
•
The wall or control cabinet must be able to withstand four times the total weight of the device.
•
The flex radius of connected cables (DVI, SDL, USB, etc.) must not be exceeded.
•
This device must be installed in a position that minimizes glare on the screen.
•
This device must be installed in a position and orientation that make viewing as easy as possible for the
operator.
1.2 Installation with clamping blocks
Clamping blocks are used to mount PP500 devices with a diagonal of 10.4", 12" or 15".
Cla
mp
in
g
le
ve
r
Spring
Cla
mp
in
g
le
ve
r
Clamping lever
Plastic (PA6)
with springs
Close
Open
Plastic (PA6)
without springs
Close
Open
Clamping lever
Figure 54: Clamping blocks
Clamping blocks are designed to clamp a maximum thickness of 10 mm and minimum thickness of 2 mm.
