Accessories
62
Power Panel C50 User's manual V1.10
8.3 0TB510x 4/6-pin terminal block
The single-row 4-pin terminal block is needed for the X2X Link interface.
The single-row 6-pin terminal block is needed for the fieldbus interfaces.
8.3.1 Order data
0TB5106.2110-01
0TB5104.2110-01
Model number
Short description
Terminal blocks
0TB5104.2110-01
Accessory terminal block, 4-pin (2.5), cage clamp, 0.5 mm²
0TB5106.2110-01
Accessory terminal block, 6-pin (2.5), cage clamp terminal block 0.5 mm²
Table 3: 0TB5104.2110-01, 0TB5106.2110-01 - Order data
8.3.2 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for this accessory
and may differ from those of the complete system. The data specified for the complete system applies
to the complete system in which this accessory is installed, for example.
The technical data in this manual is current as of its creation/publication. Subject to change without
notice.
Model number
0TB5104.2110-01
0TB5106.2110-01
Terminal block
Number of pins
4
6
Type of terminal block
Cage clamp terminal block
1)
Cage clamp terminal block
Cable type
Only copper wires (no aluminum wires!)
Pitch
2.5 mm
Connection cross section
AWG wire
26 to 20
With wire end sleeves
0.25 to 0.5 mm²
Flexible
0.14 to 0.5 mm²
Inflexible
0.14 to 0.5 mm²
Electrical properties
Nominal voltage
125 V
Nominal current
2)
4 A
Table 4: 0TB5104.2110-01, 0TB5106.2110-01 - Technical data
1)
Cage clamp terminal blocks cannot be used side-by-side.
2)
Take the respective limit data for the I/O modules into consideration!
