Device description • Power Panel C70 - 5.7" display
20
Power Panel C70 User's manual V1.30
Model number
4PPC70.0573-20W
4PPC70.0573-20B
4PPC70.057L-20W
4PPC70.057L-20B
Interfaces
Interface IF1
Fieldbus
POWERLINK V2 managing or controlled node
Type
Type 4
4)
Variant
1x RJ45 shielded
Line length
Max. 100 m between 2 nodes (segment length)
Max. transfer rate
100 Mbit/s
Transfer
Physical layer
100BASE-TX
Half-duplex
Yes
Full-duplex
POWERLINK mode: No / Ethernet mode: Yes
Autonegotiation
Yes
Auto-MDI / MDIX
Yes
Interface IF2
Type
Ethernet
Variant
1x RJ45 shielded
Line length
Max. 100 m between 2 nodes (segment length)
Max. transfer rate
10/100 Mbit/s
Transfer
Physical layer
10BASE-T/100BASE-TX
Half-duplex
Yes
Full-duplex
Yes
Autonegotiation
Yes
Auto-MDI / MDIX
Yes
Interface IF3
Type
USB 2.0
Variant
Type A
Current-carrying capacity
0.49 A
Interface IF4
Type
USB 2.0
Variant
Type A
Current-carrying capacity
≥Rev. E0: 0.20 A
<Rev. E0: 0.10 A
Interface IF5
Fieldbus
X2X Link master
Electrical properties
Nominal voltage
24 VDC -15% / +20%
Max. power consumption
5)
14.4 W
Reverse polarity protection
Yes
Electrical isolation
IF1, IF2 and IF5 with each other, with other interfaces and with the base device
Operating conditions
Permissible mounting orientations
Standard mounting orientation
Vertical
Tilt
±25°
Rotation
In 90° increments (portrait/landscape)
Installation elevation above sea level
0 to 2000 m
No limitation
>2000 m
Reduction of ambient temperature by 0.5°C per 100 m
Degree of protection per EN 60529
Front: IP65, Back: IP20
Ambient conditions
Temperature
Operation
0 to 50°C
Storage
-20 to 70°C
Transport
-20 to 70°C
Relative humidity
See temperature/humidity diagram.
Mechanical properties
Note
Order terminal blocks 1x 0TB5104.2110-01, 1x 0TB6102.2010-01 and 1x 0TB6102.2110-01 separately
Front
Design
Aluminum white pinstripe
Anthracite gray pinstripe
Aluminum white pinstripe
Anthracite gray pinstripe
Dimensions
Width
172 mm
140 mm
Height
140 mm
172 mm
Depth
51 mm
Weight
0.6 kg
Table 5: Power Panel C70 - 5.7" variants without fieldbus interfaces - Technical data
1)
The real-time clock is buffered for approx. 1000 hours @ 25°C by a gold foil capacitor. The gold foil capacitor is completely charged after 3 continuous
hours of operation.
2)
The size of the memory used for remanent variables is adjustable in Automation Studio.
3)
Value applies at an ambient temperature of 25°C. Reducing the brightness by 50% can increase the half-brightness time up to 50%.
4)
See section "Communication
⇒
POWERLINK
⇒
General information
⇒
Hardware - IF/LS" of Automation Help
5)
Measured while all communication interfaces in use.
