Bandspeed AirMaestro 3100AG, User Manual

- 2 - 

SAFETY AND REGULATORY NOTICES 

FCC STATEMENT 
 

The Bandspeed AirMaestro 3100AG Access Point has been tested and found to 
comply with the specifications for a Class B digital device, pursuant to Part 15 of 
the FCC Rules.  
 
Operation is subject to the following two conditions: 
 

1)  This device may not cause harmful interference, and 
2)  This device must accept any interference received, including interference 

that may cause undesired operation. 

These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used according to the 
instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, 
which is found by turning the equipment off and on, the user is encouraged to try 
to correct the interference by one or more of the following measures: 
 

•

  Reorient or relocate the receiving antenna; 

•

  Increase the separation between the equipment or devices; 

•

  Connect the equipment to an outlet other than the receiver's; 

•

  Consult a dealer or an experienced radio/TV technician for assistance; 

FCC Caution

: Any change or modification to the product not expressly approved 

by Bandspeed could void the user's authority to operate the device. 
 

FCC Caution:

 Operation within the 5150 to 5250GHz band is restricted to indoor 

use only. 
 

FCC RF Radiation Exposure Statement:

 To comply with the FCC and ANSI 

C95.1 RF exposure limits, the antenna(s) for this device must comply with the 
following: 
 

•

  Access points with 2.4 GHz or 5 GHz integrated antenna must operate 

with a separation distance of at least 20 cm from all persons using the 
cable provided and must not be co-located or operating in conjunction with 
any other antenna or transmitter. 

•

  End-users must be provided with specific operations for satisfying RF 

exposure compliance.