8
The Socket unit can be mounted on
the enclosed wall bracket in either a
horisontal or vertical position.
We recommend that you follow this
procedure when you mount the wall
bracket:
– Use the wall bracket to mark the
placement of the holes to be
drilled in the wall.
The dimensional sketch on this
page shows the placement of the
Socket unit compared to the wall
bracket
– Mount the wall bracket on the
wall
– Mount the Socket unit on the wall
bracket. If you place the unit close
to the floor, we suggest that you
connect all cables before
mounting the Socket unit on the
bracket
See the special notice about light
partition walls on the next page.
Should questions arise concerning
screws or fasteners, please contact
your Bang & Olufsen retailer.
Mounting the wall bracket
27 cm
10.6"
5.5 cm
2.2"
17.5 cm
6.9"
17.5 cm
6.9"
27 cm
10.6"
10 cm
3.9"
20 cm
8"
Mounting the wall bracket:
Two screws/
fasteners with a minimum load rating of 6 kg (13
lbs.) each must be used.
Fastening the Socket unit to the Wall bracket:
Slide the Socket unit down into place on the wall
bracket. Make sure that the socket unit is pushed
all the way down to engage the two lock
mechanisms.
Summary of Contents for BeoCenter 2
