64
One remote control for both televisions
Two televisions in the same room
If you have placed your BeoCenter 6
in a room where you already have a
Bang & Olufsen television, and
commands from Beo4 can be
received by both televisions, you
must change the option setting of
BeoCenter 6. This prevents
simultaneous activation of both
televisions.
For your television to function properly, it is
essential that the television is set to the
correct Option:
To set your television for Option 4 …
> While holding the • button on Beo4, press
LIST
.
> Let go of both buttons.
> Press
LIST
repeatedly to display OPTION? on
Beo4 and press
GO
.
> Press
LIST
repeatedly to display V.OPT on Beo4
and press
4
.
Operate your television in Option 4 …
Normally, you can activate a source, such as TV,
simply by pressing the relevant source button on
Beo4. However, when you set your television to
Option 4, you must do the following:
> Press
LIST
repeatedly until LINK* is shown in
the Beo4 display.
> Press a source button, such as
TV
.
*In order to display LINK on Beo4, you must add it to
the Beo4 list of functions.
In order to use teletext on a television you have set
to Option 4, you must set up Beo4 to ‘VIDEO 3’,
but this limits the Beo4 functions that can be used
with televisions set to other Options. For further
information refer to the chapter ‘Customise Beo4’
on page 66.
BeoCenter 6
Option 4
TV
LIST
LINK
TV
Downloaded from
Summary of Contents for BeoCenter 6
