Set up the loudspeaker
We recommend that you follow
this procedure:
– Disconnect your Bang & Olufsen
system from the mains.
– Mount the loudspeaker to the
Bang & Olufsen stand or wall
bracket as explained on the next
page.
– Connect the loudspeaker as
explained in
‘Cable connections’
(pp. 6–7).
– Set the POSITION switch to the
correct setting. This is explained
in
‘Adapt the loudspeaker to
your room’
(pp. 8–9).
– Connect the entire system to the
mains again.
In order not to dent or scratch the
loudspeaker front grill, we
recommend that you lift the loud-
speaker by holding on to the two
bass units on the bottom. Do not
support the loudspeaker holding
the loudspeaker front grill!
BeoLab 7 brackets:
The loud-
speaker must be fastened to one of
the brackets shown here, and on a
suitable Bang & Olufsen stand or
wall bracket.
BeoLab 7-1:
Always use the ‘type 1
bracket’.
BeoLab 7-2:
Use the ‘type 2
bracket’ when the loudspeaker will
be fastened to one of the ‘double-
column’ Bang & Olufsen stands.
However, use the ‘type 1 bracket’
if the loudspeaker will be fastened
to a wall bracket – for example
below a BeoVision 4 screen.
100 cm
39"
124 cm
49"
4
‘Type 1 bracket’
‘Type 2 bracket’
BeoLab 7-1
BeoLab 7-2
Summary of Contents for BeoLab 7-1
Page 1: ...Guide BeoLab 7 1 BeoLab 7 2...
Page 12: ...www bang olufsen com...
