26
>> Set the television to switch itself on or off
DTV Play Timer
You can program a Play Timer on a
connected Bang & Olufsen audio or
video product. If the Play Timer uses the
DVB Module in the television as source,
you must tell it which MODE it should
start in. That is should radio or television
switch on. Also you must tell it which
GROUP, that is which of the station or
channel groups should be used when
the Play Timer is executed.
To make settings for a DTV Play Timer …
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the
centre
button to bring up the
OPTIONS menu and highlight DTV PLAY
TIMER.
> Press the
centre
button to bring up the
DTV PLAY TIMER menu, and use the
navigation button up or down to move
between MODE and GROUP.
> Use the navigation button left or right to
select the setting you want.
> Press the
centre
button to store the
setting.
> Press
BACK
to back up through previous
menus or press and hold
BACK
to exit all
menus.
Note! If the TV tuner is disabled and the
DVB module is activated by pressing
TV
on
the remote control, the name of the menu is
TV PLAY TIMER.
Also remember to set the PLAY TIMER menu
to ON, if the television or its speakers are to
be activated by the Play Timer.
Standby Settings
The television can be set to switch itself
to standby after some time with no
operation. The factory setting is 4 hours.
This function only applies in video mode
not in audio mode.
To make standby settings …
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the
centre
button to bring up the
OPTIONS menu and highlight STANDBY
SETTINGS. Press the
centre
button to
bring up the STANDBY SETTINGS menu
and use the navigation button up or down
to move between AUTO STANDBY and
POWER SAVING.
> Use the navigation button left or right to
select the setting you want.
> Press the
centre
button to store the
setting.
> Press
BACK
to back up through previous
menus or press and hold
BACK
to exit all
menus.
When AUTO STANDBY is activated, a
message appears on your television screen if
the television has not been operated during
the time set in the menu. The television then
switches to standby if you do not operate it.
If you set the POWER SAVING to ON, you
cannot activate the television or its sources
from your link room, while the main room
television is in standby. Furthermore, when
POWER SAVING is set to ON you cannot
activate external PLAY TIMERs.
DTV PLAY TIMER menu
STANDBY SETTINGS menu
DTV PLAY TIMER
MODE
TV
GROUP
SPORT
STANDBY SETTINGS
AUTO STANDBY
4 HOURS
POWER SAVING
OFF
Summary of Contents for BeoVision?10-32
Page 1: ...BeoVision 10 32 Guide...
